Installing fencing posts

So, say you're putting in one panel you will need one plus one i. For 12 panels you will need 13 posts. But if this is feeling too much like a math equation simply draw up a diagram and mark out the amount of panels and where the posts will need to go.

It seems like an obvious thing to say, but preparing your area is an important step in how to install a fence post. Start by removing any plants and debris from the area where your new garden screening is to go. Then mark out a line where the fence is going. Then mark out the exact position for each fence post with a bamboo cane. It goes without saying that these should account for the width of your specific fence panel. If you're replacing an existing panel, try your best not to cause any damage to any existing plants near the fence.

Next, dig the hole for the fence posts using the best garden spade or auger. However, you should check with your local building codes before doing this,' says Thomas Goodman construction expert at Myjobquote. The diameter of the hole should also be around three times the width of the fence posts. This will prevent the posts from coming into contact with the soil.

Digging the holes for your fence posts is probably the most labour intensive part. And if you're starting to doubt your decision at this point, then remind yourself that this is a cheap fence idea which is guaranteed to save you money on labour costs. To install a fence post, you should place it in the centre of the hole and hold it in an upright position. Repeat with the second fence post.

Our top tip? Don't dig all your holes at once and rather dig as you go along. The last thing you want is getting to the point of putting in your next fence panel and finding that you haven't measured quite correctly and having to start the process all over again.

To fit your first panel between the two posts, drill six pilot holes evenly down the batten framing, use a level to check the fence is straight and hammer galvanized nails into the pilot holes to secure the panel to the post. Repeat for the other side of the panel. Once your fence panel is attached and your fence posts are ready to be set, you should then pour the concrete try postcrete for speed into the hole and around the fence post.

Water should then be poured on top of the concrete. Sand can make setting your post difficult. It is loose and makes it hard to stabilize your posts.

You may need to add a little more gravel at the bottom of your hole and around your post before adding the concrete. You will mainly have issues while digging up the hole. It may be a little tougher and can cause damage to your auger or shovel. Just take it slow, and you will succeed. The steps you follow to install your fence post will depend on the material the post is made of: wood or metal.

Be sure to checkout our other articles on fencing, such as how to stain you fence , which we provide a step by step process, and how you can cover up a fence cheaply.

Hey there and thanks for coming to our site. We love doing projects in our backyard. We do many of the projects ourselves and it's always a work in progress. Your email address will not be published. This site uses Akismet to reduce spam. Position the post in the center of the hole and hold it upright. Then, pour dry Quikrete Fast-Setting Concrete Mix into the hole, getting an even amount around all sides of the post. Continue filling the hole with the dry fast-setting concrete mix until the mix sits approximately three inches below ground level.

A pound bag of mix will make approximately 0. Pour water on top of the dry concrete mix at a ratio of about one gallon per pound bag. For the inch-deep hole mentioned above, that would require about five gallons of water. Add slowly, allowing the water to seep down and saturate the mix.

Level the post as soon as the mix and water have been added to the hole. Work quickly. Quikrete Fast-Setting Concrete Mix will set in 20 to 40 minutes, and once it hardens, the post can no longer be adjusted.

Wait four hours for the concrete to cure before continuing construction of your fence.